500 guides

Repair guides

Pick a type, an appliance or a brand. Every guide lists the tools, the safety call-outs, the steps and the reading you should expect.

Diagnostic · 374

Symptom → most likely cause, step by step

Component tests · 69

How to test a specific part, with expected readings

Installation · 33

Install, replace and hook up appliances correctly

Fundamentals · 24

Core skills every appliance tech uses

9 guides for KitchenAid

Dishwashers · 1

Guide · Dishwasher

Dishwasher upper rack drops, tilts or falls off the track

Upper racks ride on rails with end stops and, on adjustable racks, a height adjuster on each side. Broken adjuster latches, missing wheels, worn end stops or a cracked rail cause most sagging and fall-off complaints. These are snap-in parts matched to the model number.

4 steps ~30 mineasy

Microwaves · 1

Guide · Microwave

Microwave drawer will not open, close or stay closed

Rule out an obstruction, an overloaded drawer, the control lock and a power interruption, then reset at the breaker. Persistent faults point to the position/sensing switch, drawer motor, slides or the control; check for oversized mounting screws on new installs.

5 steps ~45 minmoderate

Ice Makers · 3

Guide · Ice Maker

Ice maker drain pump problems

Pump models are used when there is no gravity drain (e.g. draining to a sink). They need correct hose routing within the stated rise/run limits and tight connections. A pump that cannot discharge can stop production or cause leaks.

4 steps ~45 minmoderate

Guide · Ice Maker

Undercounter ice maker not making ice

Check power, water supply and pressure, drain (pump models stop when they cannot drain), bin sensor, cleaning status, condenser and room temperature. Scale is the most common cause on older machines.

7 steps ~60 minmoderate

Guide · Ice Maker

Undercounter ice maker: ice slab will not release or sticks on the cutting grid

Grid-cutter (slab) ice makers freeze a sheet, release it during harvest and let a heated wire grid cut it into cubes. Most release problems come from an unlevel cabinet, scale on the evaporator plate, or a cutting grid that is unplugged or not heating. Harvest switches and probes are next.

5 steps ~60 minmoderate

Range Hoods · 1

Guide · Range Hood

Telescopic downdraft vent will not rise (or fan will not run)

Telescopic downdrafts have a lift motor and a separate blower. Most calls are power (cord unplugged in the cabinet, breaker), an obstruction that triggered the safety stop, or a button that was tapped instead of held. The blower is normally interlocked and only runs with the vent fully up.

5 steps ~60 minmoderate

Trash Compactors · 3

Guide · Trash Compactor

Trash compactor drawer will not open

The drawer opens only with the ram fully up and no Solid/lock cycle active. Otherwise look for debris in the tracks, bad rollers or a foot pedal/catch problem.

4 steps ~30 mineasy

Guide · Trash Compactor

Trash compactor motor runs but the ram does not move

If the motor turns freely, the fault is in the drive train between the motor and the ram: drive chain or belt, sprockets/gears, or the plastic power nuts that ride the power screws. A broken directional/limit switch can also leave the screws turning the wrong way or not at all.

4 steps ~75 minmoderate

Guide · Trash Compactor

Trash compactor will not start

Most no-starts are power, an unlatched drawer, or the start sequence (key to Start, or On plus foot-actuated start). After that, test the drawer, key/start, toe/foot and directional switches, then the motor.

5 steps ~60 minmoderate