Electrolux EFME627-series electric dryer: quick sheet

Covers: Electrolux EFME627UTT (Titanium) 8.0 cu ft front-load electric dryer with steam, the match to the EFLS627UTT washer; the gas twin is EFMG627UTT (gas side refer-out only). Sold roughly 2020 onward; listed as discontinued by retailers.

Single sourceBrands: Electrolux7 components

A 27-inch stackable electric dryer with a stainless drum, moisture sensing with Predictive Dry, Instant Refresh and Perfect Steam options. It follows the Frigidaire/Electrolux dryer design for heat safety devices and E6x codes. Deep diagnostics: see the Frigidaire / Electrolux dryer field service manual.

Safety first

Unplug before testing; 240 V circuit
Gas model EFMG627: gas valve and burner are blocked; refer to a licensed gas technician

How it works

The motor drives the drum by belt and runs the blower (about 220 CFM listed) that moves air across the element and out the rear exhaust.

The element is guarded by a high-limit thermostat and a thermal limiter on the heater housing, plus a thermal fuse on the exhaust; the control reads an exhaust thermistor and the moisture bars, and Predictive Dry posts a time estimate after about 90 seconds.

Steam options spray a small amount of water into the drum for refresh and wrinkle release; steam faults come back to the water supply and steam valve first.

Components & tests

Unlock all 7 components, specs, service mode and teardown

Full library + AI assistant for $34.90, one time.

Get lifetime access

Official manufacturer documentation

Always confirm values against the tech sheet for the exact model.

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work. © 2026 OnCall Tech. Original content; not a reproduction of any manufacturer document.Generic part photos (not of this brand): Front-load washer and dryer pair in a home laundry room by Curtis Adams, Pexels License

Diagnostic guides for this appliance

Component test · Dryer

How to test a dryer thermal fuse

A thermal fuse is a one-time safety link that opens permanently when the exhaust gets too hot. It is a simple continuity test, but a blown fuse is a symptom: the real cause is almost always a restricted vent or a failed cycling thermostat.

5 steps ~20 mineasy

Component test · Dryer

How to test a high-limit thermostat (dryer and similar heaters)

A high-limit is a normally-closed bimetal switch that opens if the heater area overheats and closes again when it cools. A room-temperature continuity test catches the common "stuck open" failure, but it cannot prove the opening temperature is right.

5 steps ~20 mineasy

Component test · Dryer

How to test a dryer cycling (operating) thermostat

The cycling thermostat switches the heat on and off to hold the exhaust temperature. It should be closed when cold and open when hot. A stuck-closed unit overheats the dryer; a stuck-open unit gives no heat.

6 steps ~20 mineasy

Other dryers manuals

Manual · Dryer

Speed Queen dryer (DC5 / DR / DF series, gas and electric): field service manual

Speed Queen residential dryers built by Alliance Laundry: DC5 (classic mechanical controls), DR3/DR5/DR7 and DF7, about 7.0 cu ft, gas and electric versions.

6 components4 common failuresSpeed Queen

Manual · Dryer

Whirlpool / Maytag / Kenmore 29-inch dryer (electric & gas): field service manual

Whirlpool-built 29-inch full-size dryers: the older mechanical-timer / basic-electronic platform and the newer electronic-console platform with F#E# codes. Gas and electric versions. Commercial-grade residential and Duet-era front-load companions are mentioned only where noted.

15 components6 common failuresWhirlpool, Maytag, Kenmore, KitchenAid, Amana, Roper

Manual · Dryer

Samsung DV dryer (electric & gas): field service manual

Samsung DV-series 27-inch front-load-companion dryers with digital display (DVE electric / DVG gas), including models with vent-blockage sensing.

11 components5 common failuresSamsung