Repair guides
Pick a type, an appliance or a brand. Every guide lists the tools, the safety call-outs, the steps and the reading you should expect.
Diagnostic · 374
Symptom → most likely cause, step by step
Component tests · 69
How to test a specific part, with expected readings
Installation · 33
Install, replace and hook up appliances correctly
Fundamentals · 24
Core skills every appliance tech uses
Appliance
Brand-specific guides
7 guides for Whirlpool · Washers
Diagnostic · 7
Guide · WasherClassic Whirlpool/Kenmore direct-drive: agitates but won't spin
Check the lid switch first, then watch the clutch drum in spin to split the problem between the coupler/gearcase and the clutch/drive block.
Guide · WasherClean-washer reminders and clean-cycle codes (CL, rL, F0E7)
These are reminders or load-detected messages, not faults. Run the clean cycle with an empty drum.
Guide · WasherHot and cold water reversed (HC, F0E4, 4C2)
The hoses are swapped at the faucet or at the washer. Swap them; no parts needed.
Guide · WasherReading stored codes and service/test mode (overview)
Entry sequences differ by model and generation. Always confirm on the tech sheet inside the cabinet; the sequences below are examples reported for specific model families.
Guide · WasherTop-load not agitating (fills and drains OK)
On older Whirlpool/Kenmore direct-drive top-loads, fill-and-drain-OK but no agitate/spin is the classic broken motor coupler. On newer models, look at the shift actuator/clutch, lid lock and motor.
Guide · WasherWasher-dryer combo washes but does not dry
Combos are ventless and dry slowly. Clean the condenser/lint path, check load size and power (many need 240 V), then check heater or heat pump.
Guide · WasherWhirlpool/Maytag VMW top-load: F7E5 / shifter or drive fault
The control did not see the shifter or basket move as expected. Check mechanics and wiring first; the shifter (with its internal position sensor) is the most common replacement.