Whirlpool WML75011 (HZ/HW/HB) 1.1 cu ft low-profile microwave hood combination: quick sheet

Covers: Whirlpool WML75011HZ, HW, HB and Y-prefixed Canadian versions. Retailers mark it discontinued and point to the WMML5530RZ as its successor (listed at 450 CFM, 4-speed). Low-profile means it is about 10-5/16 in tall and fits where a standard OTR (about 16-17 in tall) would crowd the cooktop.

Cross-checkedBrands: Whirlpool6 components

Low-profile OTR made to replace an under-cabinet hood without losing headroom over the cooktop. The cavity is small (1.1 cu ft, about 7 in interior height), so 'my plate does not fit' is a design limit, not a fault. The vent is the strong point (400 CFM). Field work is the usual microwave set (door switches, HV parts by a trained tech, vent motor and lights) in a tighter cabinet.

Safety first

CAUTION: the high-voltage capacitor can hold a lethal charge after the unit is unplugged. Only a trained tech opens the cabinet: unplug, wait, then discharge the capacitor with an insulated discharge tool before touching the HV section (transformer, capacitor, diode, magnetron).
Never run the oven with the wrapper or panels off, with an interlock defeated, or empty; never take live readings in the HV circuit.
After any door, hinge, latch or interlock work, confirm the door closes squarely and run a leakage survey (see microwave-leakage-limit-interlock-check-after-door-repair).
OTR units are heavy and hang on a wall plate plus top-cabinet bolts: two people, and support the unit before removing the top bolts.

How it works

Standard microwave HV circuit in a shallow cabinet; the magnetron and HV parts are packed close together, so take photos before unplugging anything.

Hood side is rated 400 CFM, higher than most standard OTRs, and is set up for the house's vent mode at install.

Because it sits closer to the cooktop than a standard OTR, keep the maker's minimum height above the cooking surface from the install sheet.

Components & tests

Unlock all 6 components, specs, service mode and teardown

Full library + AI assistant + the OnCall Tech app for iPhone & Android. $34.90, one time.

Get lifetime access

Official manufacturer documentation

Always confirm values against the tech sheet for the exact model.

Whirlpool product help: over-the-range microwave error codes

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work. © 2026 OnCall Tech. Original content; not a reproduction of any manufacturer document.Generic part photos (not of this brand): Over-the-range microwave mounted above a stainless electric range by Curtis Adams, Pexels License

Diagnostic guides for this appliance

Guide · Microwave

Microwave interior paint peeling, chipped or rusted (when to stop using it)

The cavity coating protects the steel; once bare metal is exposed it can rust and act as an arcing point, and flaking paint can fall into food. Small, isolated chips on an otherwise sound cavity can sometimes be touched up with a coating made for microwave cavities, fully cured before use. Widespread peeling, rust that has pitted or holed the metal, or any damage to the door, choke or seal area means the oven should be retired. Never use ordinary paint.

6 steps ~30 mineasy

Guide · Microwave

Over-the-range microwave duct run: size, equivalent length and when to recirculate instead

OTR microwave blowers are small, so the duct decides how well they vent. The common target on manufacturer install sheets is a 3-1/4 x 10 in rectangular duct or a round duct of at least 6 in through a rectangular-to-round transition, with the whole run kept under the maker's equivalent-length limit (GE sheets seen: 120 or 140 equivalent feet depending on the document). Every fitting counts as extra feet. This guide shows how to add up a run before you cut holes, and when the honest answer is to leave the unit on recirculate with a charcoal filter.

6 steps ~30 minmoderate

Guide · Microwave

Microwave door, interlock and leakage: what the federal standard requires and what to check after a door or switch repair

US microwave ovens are built to the FDA performance standard (21 CFR 1030.10): leakage may not exceed 1 mW/cm² as sold and 5 mW/cm² for the life of the oven, measured about 5 cm (2 in) from the surface, and every oven must have two independent interlocks plus a monitoring system that stops the oven if the interlocks fail. In the field that means a damaged door, hinge or seal is a stop-use condition, every interlock part goes back exactly as designed, and a door or switch repair should end with a leakage survey using a microwave survey meter. This guide covers the checks; it does not cover high-voltage work beyond the standard discharge warning.

5 steps ~30 minadvanced

Other microwaves manuals

Manual · Microwave

Whirlpool WMH32519 (HZ/HV/HW/HB) 1.9 cu ft steam OTR microwave: quick sheet

Whirlpool WMH32519HZ (fingerprint-resistant stainless), HV, HW and HB color versions; Y-prefixed Canadian versions (YWMH32519HZ) are the same family. Retailers list the model as discontinued; check the rating label inside the door for the exact suffix.

6 components4 common failuresWhirlpool

Manual · Microwave

Maytag MMV4207 (JZ/JW/JB/JK) 1.9 cu ft OTR microwave with Dual Crisp: quick sheet

Maytag MMV4207JZ (stainless), JW, JB and JK; the earlier MMV4206 is a related generation with a different feature set. Check the label inside the door for the exact model.

7 components3 common failuresMaytag

Manual · Microwave

Samsung ME16A4021 (AS/AB/AW) 1.6 cu ft OTR microwave: quick sheet

Samsung ME16A4021AS (stainless), AB (black) and AW (white); 'A' = 2021 model-year letter. Entry-level OTR often installed in rentals and builder kitchens.

6 components3 common failuresSamsung