Smooth glass electric cooktop built into a wooden counter
Generic photo: Max Vakhtbovych · Pexels License

How to test a washer water inlet valve (screens, coils, pressure)

Rule out supply first, clean the hose screens, then test each solenoid coil with power off. Coil resistance varies by brand; an open or near-zero reading is the clear failure.

Single source ~30 min easyBrands: All

Before you start

  • Unplug and turn off both faucets.
  • Have a bucket for hose water.

Diagnostic steps

Unlock all 7 steps with expected values

Full library + AI assistant for $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More washers guides

Guide · Washer

Replacing a front-load washer door boot (bellows seal)

The door boot is held by an outer clamp at the cabinet front and an inner clamp on the tub. Remove the front panel on most models, release both clamps, align the new boot with the tub mark and reinstall the inner clamp first.

8 steps ~75 minmoderate
Guide · Washer

Front-load washer shock absorbers (dampers): test and replace

Front-loaders hang the tub on springs and dampers underneath. A worn damper lets the tub bounce. Test by pressing the tub down; replace dampers in pairs.

7 steps ~60 minmoderate
Guide · Washer

Whirlpool/Maytag VMW HE top-load: replacing the suspension rods

Whirlpool-built HE top-loaders (Cabrio, Bravos, WTW5000-type and similar) hang the tub from four spring-damped suspension rods. As the damper ends wear, the tub sags and swings into the cabinet during spin. The rods are sold as a four-piece kit and should be replaced together; access is from the top after lifting the top panel.

7 steps ~45 minmoderate
How to test a washer water inlet valve (screens, coils, pressure) · OnCall Tech