Smooth glass electric cooktop built into a wooden counter

Generic photo: Max Vakhtbovych · Pexels License

Replace the surface element infinite switch (electric coil or radiant range)

Each surface element has an infinite (cycling) switch behind the control panel. Swap the element with a known-good one (coil tops) or test it first, check the receptacle/terminal block for burning, then replace the switch wire for wire. Match the switch to the element size and wattage.

Cross-checked ~40 min moderateBrands: All

Before you start

Unplug the range or turn off both breaker legs and verify 0 V before opening the control panel.
Slide the range out and back carefully; re-engage the anti-tip bracket after the repair.
Do not operate the range with the back panel or console open.

Diagnostic steps

Unlock all 9 steps with expected values

Full library + AI assistant + the OnCall Tech app for iPhone & Android. $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More ranges & ovens guides

Guide · Range / Oven

Electric range trips the breaker or blows a fuse

Use the timing of the trip to split the problem. A trip at power-up, with every control off, points to the supply cord, terminal block, internal wiring or the breaker itself. A trip only when one element or mode is turned on points to that element (usually shorted to its sheath) or its switch and wiring. Rule out a weak or undersized breaker last, after the range itself tests clean.

8 steps ~60 minmoderate

Guide · Range / Oven

Electric range partly works: display on, oven or big elements won't heat

An electric range runs its electronics and lights on 120 V (one hot leg to neutral) but heats with 240 V across both legs. If one leg is lost, the range looks alive but cannot heat properly. Typical causes are half of the double-pole breaker tripped or failed, a burned terminal block or cord connection, or a damaged receptacle. A building on 208 V will heat, just more slowly.

7 steps ~45 minmoderate

Guide · Range / Oven

Oven keeps heating when turned off or overheats past setpoint

This is a fire hazard: turn the breaker off first, then diagnose. On electronic controls the usual cause is a relay on the control board whose contacts have welded closed. On dial ovens it is a stuck thermostat or selector contact. Less often a shorted sensor or harness is to blame. On gas ovens, a burner that won't shut off is a gas-valve problem and goes to a licensed gas technician.

7 steps ~60 minadvanced