Row of built-in wall ovens in a modern kitchen
Generic photo: Max Vakhtbovych · Pexels License

Replace the oven bake element (electric range or wall oven)

Exposed bake elements are held by two screws at the back wall and come out from inside the oven; hidden elements sit under the oven floor and are reached by removing the floor panel (or from the rear on some models). Kill both breaker legs, pull the element forward, move the wires without letting them drop into the wall, and test that it glows and holds temperature.

Cross-checked ~30 min easyBrands: All

Before you start

  • Turn off both breaker legs feeding the range (or unplug a freestanding range) and verify 0 V before touching the element terminals.
  • Let the oven cool fully.
  • Pull spade connectors by the metal terminal, not the wire, and do not let the wires fall back through the rear wall.

Diagnostic steps

Unlock all 9 steps with expected values

Full library + AI assistant + the OnCall Tech app for iPhone & Android. $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More ranges & ovens guides

Guide · Range / Oven

Electric range trips the breaker or blows a fuse

Use the timing of the trip to split the problem. A trip at power-up, with every control off, points to the supply cord, terminal block, internal wiring or the breaker itself. A trip only when one element or mode is turned on points to that element (usually shorted to its sheath) or its switch and wiring. Rule out a weak or undersized breaker last, after the range itself tests clean.

8 steps ~60 minmoderate
Guide · Range / Oven

Electric range partly works: display on, oven or big elements won't heat

An electric range runs its electronics and lights on 120 V (one hot leg to neutral) but heats with 240 V across both legs. If one leg is lost, the range looks alive but cannot heat properly. Typical causes are half of the double-pole breaker tripped or failed, a burned terminal block or cord connection, or a damaged receptacle. A building on 208 V will heat, just more slowly.

7 steps ~45 minmoderate
Guide · Range / Oven

Oven keeps heating when turned off or overheats past setpoint

This is a fire hazard: turn the breaker off first, then diagnose. On electronic controls the usual cause is a relay on the control board whose contacts have welded closed. On dial ovens it is a stuck thermostat or selector contact. Less often a shorted sensor or harness is to blame. On gas ovens, a burner that won't shut off is a gas-valve problem and goes to a licensed gas technician.

7 steps ~60 minadvanced
Replace the oven bake element (electric range or wall oven) · OnCall Tech