Inside a worn garbage disposal: rusty grinding plate and lugs seen from the sink

Field pattern: disposal 'leaking from the bottom, replace it' (rule out elbow gasket and hoses before condemning)

A true leak from the body (often at the reset button or bottom cover) means the internal seals or housing failed, and the unit gets replaced because those seals are not sold as parts. But water from a dishwasher hose, a loose discharge elbow or a bad elbow gasket can run down the shell and drip off the bottom too; Moen notes an elbow gasket leak can exit through the bottom plate. Do the towel test first.

Cross-checked ~30 min easyBrands: All

Before you start

Turn off the disposal at the switch and breaker before inspecting under it
A unit leaking from the body near the electrical cover must stay unplugged

Diagnostic steps

Unlock all 6 steps with expected values

Full library + AI assistant + the OnCall Tech app for iPhone & Android. $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More garbage disposals guides

Guide · Garbage Disposal

Disposal sink-top air switch (push button) not working

An air switch sends a puff of air down a small tube to a power module under the sink, which toggles the outlet the disposal plugs into. Check the disposal itself first, then the tube, the button and the module. Some InSinkErator single-outlet SinkTop Switch modules (2005-2017) were recalled for water entry and overheating.

6 steps ~30 mineasy

Guide · Garbage Disposal

Garbage disposal trips the GFCI (not the breaker)

A GFCI trips on current leaking to ground, not on overload. A wet or failing disposal (bottom leak into the motor, damaged cord, bad splice) is the most likely cause; motor leakage on older units and a shared circuit with the dishwasher can add up. Diagnose the leak; never solve it by removing GFCI protection where the local code requires it.

7 steps ~45 minmoderate

Guide · Garbage Disposal

Field pattern: 'disposal is dead, needs a new one' (reset, jam and power first; a leaking body is the real replace)

Most dead or humming disposals are a jam that tripped the overload, a tripped GFCI or breaker, or a wall or air switch fault. Freeing the flywheel with the hex key and pressing the reset button is the first step. The opposite trap is fixing a jam on a unit that leaks from the body; that one needs replacing.

6 steps ~30 mineasy