A.O. Smith / State · Water Heater error code

7 flashesGas control failure

Cross-checked Licensed pro only

Unlock what this code means, its causes, tests and parts

Full library + AI assistant for $34.90, one time.

Stop: this involves gas or the sealed refrigerant system.

OnCall Tech only describes the symptom. Gas work needs a licensed gas technician, and refrigerant work requires EPA Section 608 certification. If you smell gas: shut off the supply if it is safe, do not switch anything on or off, ventilate, leave the building and call the gas utility.

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

Related diagnostic guides

Guide · Water Heater

Water heater: water too hot or ECO keeps tripping

On electric tanks overheating usually means a thermostat welded closed or not clamped tightly against the tank, or a grounded element heating outside thermostat control. On gas tanks it is a gas control fault and must be referred. Treat it as a safety call: overheated water is a scald and tank-pressure hazard.

6 steps ~45 minmoderate

Guide · Water Heater

Gas water heater: pilot won't light or won't stay lit (diagnose and refer)

Standing-pilot gas tanks use a thermocouple or thermopile heated by the pilot to hold the gas valve open; FVIR models add a thermal switch and flame arrestor. This is a gas appliance: the tech's role here is to read the status light, confirm gas supply, note symptoms and hand off. Pilot assembly, thermocouple/thermopile, burner and gas valve work go to a licensed plumber or gas technician.

5 steps ~20 minadvanced