No water from the well

Check what you can safely see above ground: breaker, pressure switch, sensing tube, low-pressure cutoff and the drive's fault display. If those are good, the problem is down the well (pump, motor, cable, water level) and needs a licensed well contractor to pull the pump.

Single source ~60 min advancedBrands: Goulds, Red Lion, Franklin Electric, Others

Before you start

  • Well pumps run on 115 V or 230 V with high current; live testing is caution and for qualified persons only
  • A breaker that trips again immediately means a short: do not keep resetting
  • Pulling a submersible pump is a licensed well-contractor job

Diagnostic steps

Unlock all 5 steps with expected values

Full library + AI assistant for $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More sump & well pumps guides

No water from the well · OnCall Tech