Front-load washer and dryer pair in a home laundry room
Generic photo: Curtis Adams · Pexels License

Stacking a washer and dryer with a stacking kit

Only stack front-load pairs the manufacturer lists as stackable, using that brand's kit for those models. The kit brackets attach to the washer top and hold the dryer feet; some kits also need a wall anchor. Lifting the dryer is a two-person job.

Cross-checked ~60 min moderateBrands: All

Before you start

  • Unplug both units (or breaker off) before starting.
  • Two people to lift the dryer; never lift by the door.
  • Do not lay the dryer on its face or top on a hard floor.

Diagnostic steps

Unlock all 5 steps with expected values

Full library + AI assistant for $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More washers guides

Component test · Washer

How to test a drain pump (washer and dishwasher)

Most drain pumps are small synchronous motors. Clear the filter and impeller first, then test the winding and the voltage. Published resistance values vary a lot by brand, so use the tech sheet for the number.

6 steps ~40 minmoderate
Component test · Washer

How to test a universal (brushed) motor and its carbon brushes

Universal motors run on AC or DC through carbon brushes that rub on a commutator. Brushes wear out and are the most common failure. Check brush length and the commutator, then test the field and armature with a meter.

6 steps ~60 minmoderate
Component test · Washer

How to test a top-load washer lid switch / lid lock

Older top-loaders use a simple lid switch; most newer ones use a lid lock with a switch and a locking solenoid or motor. Test the switch contacts with the lid open and closed, and check the lock coil if there is one.

6 steps ~20 minmoderate
Stacking a washer and dryer with a stacking kit · OnCall Tech