TVs

TV wall mounting: studs, VESA, cable routing and in-wall power

Choose a mount that matches the TV VESA pattern and weight, anchor it into studs (or masonry anchors on brick/concrete), and hide cables only with in-wall-rated cable or a recessed power kit. Running the TV power cord itself inside the wall is not an accepted practice under the electrical code: use a listed in-wall power kit or a new outlet installed by an electrician where required.

Single source ~90 min moderateBrands: All

Before you start

  • Check for wiring and pipes before drilling (stud finder with AC detection).
  • Two people to hang the TV.
  • In-wall power: listed recessed power kits or an electrician; never fish the TV power cord through the wall.

Diagnostic steps

Unlock all 6 steps with expected values

Full library + AI assistant for $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More tvs guides

Component test · TV

TV LED backlight strips and LED driver

LED strips are wired in series strings and run from a constant-current driver at high DC voltage (often around 80-200 V total). One dead LED opens the string and the driver shuts down. Test LEDs with a backlight tester, not a meter diode range, and replace all strips as a set.

6 steps ~120 minadvanced
Component test · TV

T-con (timing control) board: board or panel?

The T-con converts video from the main board into the signals that drive the panel rows and columns. Loose ribbons, a blown T-con fuse or a failed T-con cause image faults; lines that stay fixed in the same place usually mean the panel itself.

5 steps ~45 minadvanced
Component test · TV

TV power supply board

The power supply board makes a standby voltage that is always on, then switches on the main rails when the main board sends a power-on signal. Check standby, then the power-on signal, then main rails. The primary side holds a high-voltage charge.

5 steps ~45 minadvanced
TV wall mounting: studs, VESA, cable routing and in-wall power · OnCall Tech