Trash compactor undercounter install

Undercounter compactors slide into a standard opening and plug into a grounded 120 V outlet placed beside the unit. Check the opening height so the top clears the counter, level the unit and secure it as the instructions require.

Single source ~45 min easyBrands: All

Before you start

Keep hands out of the drawer while the ram is operating; test with the drawer closed only.
No extension cords; use the outlet type and circuit the instructions require.

Diagnostic steps

Unlock all 5 steps with expected values

Full library + AI assistant for $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More trash compactors guides

Guide · Trash Compactor

Trash compactor motor runs but the ram does not move

If the motor turns freely, the fault is in the drive train between the motor and the ram: drive chain or belt, sprockets/gears, or the plastic power nuts that ride the power screws. A broken directional/limit switch can also leave the screws turning the wrong way or not at all.

4 steps ~75 minmoderate

Guide · Trash Compactor

Trash compactor will not start

Most no-starts are power, an unlatched drawer, or the start sequence (key to Start, or On plus foot-actuated start). After that, test the drawer, key/start, toe/foot and directional switches, then the motor.

5 steps ~60 minmoderate

Guide · Trash Compactor

Ram stuck down or will not travel

Check the drive chain/gears, then the directional switch, then the power nuts on the power screws. The ram can be raised by turning the drive gear by hand with the unit unplugged.

5 steps ~90 minadvanced