Lever microswitch, the type used for door and position sensing in appliances

Generic photo: Raimond Spekking · CC BY-SA 4.0

How to test a washer water-level pressure switch

The level switch reads air pressure trapped in a hose from the bottom of the tub. As water rises, pressure flips its contacts. Most failures are a clogged or leaking air hose, not the switch.

Single source ~20 min moderateBrands: All

Before you start

Unplug the appliance or turn off the breaker before opening panels or disconnecting parts
Take a photo of the wiring before removing any wire
Resistance and continuity tests are done with power OFF and the part isolated

Diagnostic steps

Unlock all 6 steps with expected values

Full library + AI assistant for $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More washers guides

Component test · Washer

How to test a drain pump (washer and dishwasher)

Most drain pumps are small synchronous motors. Clear the filter and impeller first, then test the winding and the voltage. Published resistance values vary a lot by brand, so use the tech sheet for the number.

6 steps ~40 minmoderate

Component test · Washer

How to test a universal (brushed) motor and its carbon brushes

Universal motors run on AC or DC through carbon brushes that rub on a commutator. Brushes wear out and are the most common failure. Check brush length and the commutator, then test the field and armature with a meter.

6 steps ~60 minmoderate

Component test · Washer

How to test a top-load washer lid switch / lid lock

Older top-loaders use a simple lid switch; most newer ones use a lid lock with a switch and a locking solenoid or motor. Test the switch contacts with the lid open and closed, and check the lock coil if there is one.

6 steps ~20 minmoderate