Clothes dryer with its vent duct in a small laundry closet
Generic photo: Introspectivedsgn · Pexels License

Speed Queen dryer runs but does not heat (electric)

Most cases are a blown thermal fuse and/or failed high-limit caused by a restricted vent. Clear the vent before replacing parts, then test the fuse, high-limit and element.

Single source ~60 min moderateBrands: Speed Queen

Before you start

  • Unplug the 240 V supply before testing.
  • Gas models: do not work on the gas side; refer to a licensed gas technician.

Diagnostic steps

Unlock all 4 steps with expected values

Full library + AI assistant for $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More dryers guides

Component test · Dryer

How to test a dryer thermal fuse

A thermal fuse is a one-time safety link that opens permanently when the exhaust gets too hot. It is a simple continuity test, but a blown fuse is a symptom: the real cause is almost always a restricted vent or a failed cycling thermostat.

5 steps ~20 mineasy
Component test · Dryer

How to test a high-limit thermostat (dryer and similar heaters)

A high-limit is a normally-closed bimetal switch that opens if the heater area overheats and closes again when it cools. A room-temperature continuity test catches the common "stuck open" failure, but it cannot prove the opening temperature is right.

5 steps ~20 mineasy
Component test · Dryer

How to test a dryer cycling (operating) thermostat

The cycling thermostat switches the heat on and off to hold the exhaust temperature. It should be closed when cold and open when hot. A stuck-closed unit overheats the dryer; a stuck-open unit gives no heat.

6 steps ~20 mineasy
Speed Queen dryer runs but does not heat (electric) · OnCall Tech