Clothes dryer with its vent duct in a small laundry closet
Generic photo: Introspectivedsgn · Pexels License

Replace the dryer drum rollers and idler pulley (Whirlpool-built 29 in)

On the common Whirlpool-built 29 in dryer, two rear rollers and the idler pulley wear together. Replace both rollers, the idler and the belt as a set (kits exist for this platform). The drum must come out: open the top, remove the front panel, release the belt from the idler, lift the drum out, then swap the parts on the rear bulkhead.

Cross-checked ~75 min moderateBrands: Whirlpool, Kenmore (Whirlpool-built), Maytag (Whirlpool-built), Roper, Estate, Amana (Whirlpool-built)

Before you start

  • Unplug the dryer (gas models: unplug only, do not disconnect or move the gas line; if the unit must come far forward, refer the gas connection to a licensed installer).
  • The idler arm is spring loaded; release it slowly so it does not pinch fingers or snap into the belt switch.
  • Sheet-metal edges are sharp: wear gloves.

Diagnostic steps

Unlock all 10 steps with expected values

Full library + AI assistant + the OnCall Tech app for iPhone & Android. $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More dryers guides

Guide · Dryer

Ventless dryer not drying: cleaning the filters, condenser and heat exchanger

Ventless dryers depend on clean air passages. Lint that gets past the door filter settles on the condenser or heat exchanger and drying time climbs. Clean every filter stage first, then the condenser or exchanger, then check the water path.

8 steps ~40 mineasy
Guide · Dryer

Dryer squeaks, squeals or thumps: drum rollers, idler pulley, glides and rear bearing

Drum noise usually comes from four wear parts: the drum support rollers (thump, squeak), the idler pulley (squeal or whine), the front glides or bearing slides (scraping) and, on some designs, a rear drum bearing (squeal, drum moves front to back). Take the belt off and turn the drum by hand to find which one it is. Replace rollers as a set.

9 steps ~75 minmoderate
Guide · Dryer

Replacing a broken or slipping dryer drum belt

A broken belt leaves the motor spinning with no drum movement. Open the cabinet, put the new belt around the drum with the ribbed side against the drum, then route it through the idler and onto the motor pulley. Inspect the idler and rollers while you are in there.

7 steps ~50 minmoderate
Replace the dryer drum rollers and idler pulley (Whirlpool-built 29 in) · OnCall Tech