Demo / showroom mode stuck (OFF, OF OF, 'cooling off')

Demo (showroom) mode runs lights and display with cooling off. It's a key combination, not a repair. If it returns after exit, the panel may be faulty.

Cross-checked ~10 min easyBrands: All

Diagnostic steps

Unlock all 5 steps with expected values

Full library + AI assistant for $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More refrigerators guides

Component test · Refrigerator

How to test a refrigerator bi-metal defrost thermostat

The bi-metal (defrost termination thermostat) is wired in series with the defrost heater. It is closed only when the evaporator is cold and opens once the coil warms during defrost. Testing it at room temperature gives a false "bad" result: it must be cold.

5 steps ~45 minmoderate

Component test · Refrigerator

How to test a refrigerator defrost heater

The defrost heater (glass tube, metal sheath or foil type) melts frost off the evaporator a few times a day. A good heater reads in the low tens of ohms; use the wattage math to check the exact value.

5 steps ~45 minmoderate

Component test · Refrigerator

How to check an ECM / brushless DC fan motor (what you can test safely)

Many modern refrigerator fans are brushless DC motors with their electronics inside the motor. An ohmmeter cannot judge them reliably. The safe test is to confirm the supply voltage and control/feedback signals at the connector, then swap the motor if the signals are right.

5 steps ~30 minmoderate