Find the right parts for a rebadged unit (cross-reference without guessing)

Never cross-reference by appearance or by 'same maker' alone. Pull the parts list with the badge's full model number, read the OEM part number from it, and then buy that OEM number from any source. Use a twin model only when its parts list shows the identical OEM number.

Cross-checked ~15 min easyBrands: All

Before you start

Confirm the failure before ordering; follow the platform manual's safety rules when testing.

Diagnostic steps

Unlock all 6 steps with expected values

Full library + AI assistant + the OnCall Tech app for iPhone & Android. $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More tech fundamentals guides

Guide · Fundamentals

Blower runs nonstop and no cooling on a new HVAC system: A2L refrigerant leak sensor

A2L systems carry a refrigerant leak sensor near the indoor coil. When it reports a leak, or when the sensor fails or loses communication, the control stops the compressor and runs the blower to dilute any refrigerant. This guide separates a sensor or wiring fault from a possible real leak; any real leak is referred to an EPA 608 technician.

8 steps ~40 minmoderate

Guide · Fundamentals

Confirming an inverter board's DC bus is discharged before you touch it

Inverter boards store high-voltage DC in large capacitors after the power is off, and a dark LED does not mean the board is safe. Remove power, wait the maker's time, then measure the DC bus at the marked test points until it reads 0 V. Only then unplug loads or handle the board.

7 steps ~20 minmoderate

Guide · Fundamentals

Load will not turn off: shorted triac or welded relay (board vs load)

When a load runs with no command, the board output that feeds it is usually shorted: triacs most often fail shorted and relay contacts can weld closed after inrush. Confirm the output is truly on with the load connected (not a ghost reading), then test the load itself, because a shorted or seized load is what usually kills the output.

8 steps ~40 minmoderate