Hands holding multimeter probes on motor wiring terminals
Generic photo: Bulat843 · Pexels License

Oven temperature inaccurate (runs hot or cold)

First measure properly: ovens cycle above and below setpoint, so use an average over several cycles. Small offsets are fixed with the control's calibration setting; large errors usually mean a drifting sensor, a weak element or igniter, or a door gasket leak.

Cross-checked ~60 min easyBrands: All

Before you start

  • Use oven mitts when placing probes in a hot oven
  • Power off before testing the sensor

Diagnostic steps

Unlock all 5 steps with expected values

Full library + AI assistant for $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More ranges & ovens guides

Component test · Range / Oven

How to test an oven RTD temperature sensor

Most electronic ovens use a platinum RTD probe, which works the opposite way to an NTC: resistance rises with heat. Many common sensors read about 1,080 Ω at room temperature and climb roughly 2 Ω per °F.

6 steps ~20 mineasy
Component test · Range / Oven

How to test an oven bake or broil element

Bake and broil elements are 240 V resistance heaters. A good one reads somewhere in the teens to about 40 Ω depending on wattage, and never shows continuity to its metal sheath.

6 steps ~20 mineasy
Component test · Range / Oven

How to test an infinite switch (electric surface element)

An infinite switch cycles a surface element on and off to set the heat level. Test the two line-to-element contact pairs on high and off. Also test the element itself before replacing the switch.

6 steps ~20 mineasy
Oven temperature inaccurate (runs hot or cold) · OnCall Tech