LG LE code: testing the hall sensor and stator

LE means the board drove the motor but did not see rotation. Check the harness, then test the hall sensor (about 10 kΩ per channel and a pulsing signal), then the stator windings, before condemning the board.

Cross-checked ~60 min advancedBrands: LG

Before you start

Unplug and wait several minutes before touching motor wiring.
Never measure voltage on motor phase wires.

Diagnostic steps

Unlock all 5 steps with expected values

Full library + AI assistant for $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More washers guides

Component test · Washer

How to test a drain pump (washer and dishwasher)

Most drain pumps are small synchronous motors. Clear the filter and impeller first, then test the winding and the voltage. Published resistance values vary a lot by brand, so use the tech sheet for the number.

6 steps ~40 minmoderate

Component test · Washer

How to test a universal (brushed) motor and its carbon brushes

Universal motors run on AC or DC through carbon brushes that rub on a commutator. Brushes wear out and are the most common failure. Check brush length and the commutator, then test the field and armature with a meter.

6 steps ~60 minmoderate

Component test · Washer

How to test a top-load washer lid switch / lid lock

Older top-loaders use a simple lid switch; most newer ones use a lid lock with a switch and a locking solenoid or motor. Test the switch contacts with the lid open and closed, and check the lock coil if there is one.

6 steps ~20 minmoderate