Washer and dryer side by side under a wall-mounted water heater

Generic photo: Pușcaș Adryan · Pexels License

Gas dryer connection (BLOCKED: refer to a licensed gas installer)

Connecting, disconnecting or leak-testing a gas line is licensed gas work in most US jurisdictions. A handyman may prepare the space, the 120 V outlet and the vent, then the gas connection and leak test go to a licensed gas installer or plumber.

Single source ~30 min advancedBrands: All

Before you start

BLOCKED: no gas connection, gas valve or leak-test procedure in this guide.
Smell of gas: do not operate switches; leave the area and call the gas utility from outside.

Diagnostic steps

Unlock all 4 steps with expected values

Full library + AI assistant for $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More dryers guides

Component test · Dryer

How to test a dryer thermal fuse

A thermal fuse is a one-time safety link that opens permanently when the exhaust gets too hot. It is a simple continuity test, but a blown fuse is a symptom: the real cause is almost always a restricted vent or a failed cycling thermostat.

5 steps ~20 mineasy

Component test · Dryer

How to test a high-limit thermostat (dryer and similar heaters)

A high-limit is a normally-closed bimetal switch that opens if the heater area overheats and closes again when it cools. A room-temperature continuity test catches the common "stuck open" failure, but it cannot prove the opening temperature is right.

5 steps ~20 mineasy

Component test · Dryer

How to test a dryer cycling (operating) thermostat

The cycling thermostat switches the heat on and off to hold the exhaust temperature. It should be closed when cold and open when hot. A stuck-closed unit overheats the dryer; a stuck-open unit gives no heat.

6 steps ~20 mineasy