Inside a worn garbage disposal: rusty grinding plate and lugs seen from the sink

Disposal sink flange leaking: reseal

Remove the disposal, reseat the sink flange with fresh plumber's putty and gaskets, then remount and leak test.

Cross-checked ~60 min moderateBrands: All

Before you start

Turn off power at the breaker or unplug before reaching into or under the disposal
Never put hands in the grinding chamber; use the hex wrench or tongs

Diagnostic steps

Unlock all 3 steps with expected values

Full library + AI assistant for $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More garbage disposals guides

Guide · Garbage Disposal

Garbage disposal hums but won't turn (jammed)

A humming disposal almost always has a jammed turntable: a hard object or packed waste is stopping the motor. Free the plate with the hex wrench from below (or a wrench on the impellers from above), clear the debris, then reset the overload. Never put a hand in the grinding chamber.

6 steps ~20 mineasy

Guide · Garbage Disposal

Garbage disposal dead: no hum, no power

Work from the simplest cause: the motor overload (red reset), then the breaker and outlet, then the switch type (wall switch, air switch, batch-feed stopper switch). Replace the disposal only after power is proven at the outlet and the reset does nothing.

5 steps ~30 mineasy

Guide · Garbage Disposal

Garbage disposal leaking: top, middle or bottom

Find the exact leak point with the paper-towel test. Top = sink flange seal or mounting; middle = dishwasher inlet or discharge elbow; bottom = water inside the housing. Flange and connection leaks are fixable; water from the motor housing itself usually means internal seal failure and replacement.

5 steps ~45 mineasy