Noisy furnace (squeal, rattle, roar, boom)

Mechanical noises (squeal, grind, rattle) usually come from the blower or inducer and can be checked with power off. A loud boom at ignition or roaring flame is a gas/combustion problem that must be referred.

Single source ~45 min moderateBrands: All

Before you start

If you smell gas: do not operate switches or the furnace, leave the building and call the gas utility from outside.
Make sure the home has a working carbon monoxide (CO) alarm; if it is sounding or anyone has headache/nausea, get everyone out and call 911 / the gas utility.
Turn off power at the furnace service switch or breaker before opening the burner or blower compartment; the door switch alone is not a lockout.
Gas-side diagnosis or repair (gas valve, gas pressure, burners, heat exchanger, venting) is for a licensed gas/HVAC technician only.
Never jumper or bypass a limit, rollout or pressure switch.

Diagnostic steps

Unlock all 4 steps with expected values

Full library + AI assistant for $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More furnaces guides

Component test · Furnace

How to test a gas furnace draft pressure switch (electrical and draft checks only)

The pressure switch proves the inducer is pulling enough draft before ignition is allowed. Test it with a meter (24 V across it) and a manometer against the set point printed on the switch. Gas valve, gas pressure and burner work are not covered: refer those to a licensed gas technician.

5 steps ~30 minadvanced

Guide · Furnace

Furnace runs no heat (blower only or nothing)

Start with the board LED code, then work the call path: thermostat, 24 V, safeties, inducer, ignition, flame proving. Most no-heat calls end at a filter, a flame sensor, a pressure switch issue or gas being off.

5 steps ~45 minmoderate

Guide · Furnace

Furnace short cycling (starts and stops quickly)

Short cycling is usually a safety opening mid-cycle (limit from low airflow, flame sensor dropping out, pressure switch opening) or a thermostat issue. Read the code and time the cycle.

4 steps ~45 minmoderate