Freezer clicking, compressor not running

Same pattern as fridges: start relay or overload most often, then supply voltage, then compressor. Compressor work is sealed-system: refer.

Single source ~45 min moderateBrands: All

Before you start

Unplug the unit (or shut off the breaker) before removing panels or touching wiring.
Never open or recharge the sealed refrigerant system: compressor replacement, leaks and refrigerant work go to an EPA 608-certified technician.
Live voltage checks: use insulated probes and keep hands clear.

Diagnostic steps

Unlock all 4 steps with expected values

Full library + AI assistant for $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More freezers guides

Guide · Freezer

Freezer not freezing (food soft, compressor running or not)

Rule out setting, load and door seal first, then airflow and condenser, then start components. On frost-free uprights, a choked evaporator from a defrost failure is a top cause. If the compressor runs steadily, the condenser is clean and the evaporator is not frosted but the cabinet still won't pull down, it is a sealed-system issue to refer out.

7 steps ~60 minmoderate

Guide · Freezer

Freezer frost build-up (gasket, manual defrost chest, frost-free failure)

Most chest and many small upright freezers are manual defrost, so some frost is normal and must be removed when it reaches about 1/4 inch. Fast or patchy frost near the door points to a leaking gasket or heavy door use. On frost-free uprights, frost on the coil behind the panel means the defrost system has failed.

5 steps ~45 mineasy

Guide · Freezer

Freezer runs all the time

Freezers normally run 40-80% of the time at room temperature and more in a warm room. Check load, setting, room temperature, door seal and condenser before suspecting a part.

5 steps ~30 mineasy