Moisture sensor problems (auto dry wrong)

Moisture sensing uses two metal bars that wet clothes bridge. Residue, unlevel installs, small loads and loose wiring cause most complaints.

Cross-checked ~20 min easyBrands: All

Before you start

Unplug before accessing sensor wiring

Diagnostic steps

Unlock all 3 steps with expected values

Full library + AI assistant for $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More dryers guides

Component test · Dryer

How to test a dryer thermal fuse

A thermal fuse is a one-time safety link that opens permanently when the exhaust gets too hot. It is a simple continuity test, but a blown fuse is a symptom: the real cause is almost always a restricted vent or a failed cycling thermostat.

5 steps ~20 mineasy

Component test · Dryer

How to test a high-limit thermostat (dryer and similar heaters)

A high-limit is a normally-closed bimetal switch that opens if the heater area overheats and closes again when it cools. A room-temperature continuity test catches the common "stuck open" failure, but it cannot prove the opening temperature is right.

5 steps ~20 mineasy

Component test · Dryer

How to test a dryer cycling (operating) thermostat

The cycling thermostat switches the heat on and off to hold the exhaust temperature. It should be closed when cold and open when hot. A stuck-closed unit overheats the dryer; a stuck-open unit gives no heat.

6 steps ~20 mineasy