Built-in dishwasher with the door open and racks pulled out
Generic photo: Castorly Stock · Pexels License

Dishwasher not draining / standing water

Work from cheapest to costliest: filter and sump, drain hose and disposer/air gap, then pump impeller, then pump power. Water that returns 30-60 minutes after a good drain points to the check valve.

Cross-checked ~45 min easyBrands: All

Before you start

  • Turn off power at the breaker before reaching into the sump or pump
  • Watch for broken glass in the sump

Diagnostic steps

Unlock all 5 steps with expected values

Full library + AI assistant for $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More dishwashers guides

Component test · Dishwasher

How to test a dishwasher heating element

Many US dishwashers have a hidden or visible loop element under the tub. A good one reads in the tens of ohms. A leak to the tub trips the GFCI even when the resistance looks fine, so always check to ground.

5 steps ~20 mineasy
Component test · Dishwasher

How to test a dishwasher circulation (wash) pump motor

The wash motor pushes water to the spray arms. Older units use an AC induction motor; many newer ones use a brushless DC motor driven by the board. Rule out a jam and a filter clog before testing, and use the tech sheet for winding values.

6 steps ~45 minmoderate
Component test · Dishwasher

How to test a float switch (dishwasher overfill and similar)

A float rides up with water and opens or closes a small switch under the tub. It stops overfill or flags a leak. Make sure the float moves freely before blaming the switch.

6 steps ~20 mineasy
Dishwasher not draining / standing water · OnCall Tech