Dehumidifiers

Bucket full light (or P1/P2/Eb) stays on with an empty bucket

The bucket switch logic depends on a float and a small switch or magnet. A misseated or warped bucket, a float stuck with slime, or a failed float switch causes a false full signal. On units drained by hose, a loose hose connection can leak water into the bucket.

Cross-checked ~25 min easyBrands: All

Before you start

  • Unplug before reaching into the bucket cavity

Diagnostic steps

Unlock all 5 steps with expected values

Full library + AI assistant for $34.90, one time.

Get lifetime access

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

More dehumidifiers guides

Guide · Dehumidifier

Dehumidifier error codes: general approach (sensor, bucket, pump)

Most portable dehumidifiers share the same code groups: sensor faults (E1/E2/EH), bucket (P1/FL), pump (E5/P2) and refrigeration protection (E3/EC). Power-cycle and basic checks fix many; sensor faults need a part.

4 steps ~30 mineasy
Guide · Dehumidifier

Dehumidifier won't turn on (no display)

Check outlet, cord and any reset button first. Then internal fuse, transformer (on some whole-house units) and the control board.

4 steps ~45 minmoderate
Guide · Dehumidifier

Dehumidifier humidity reading wrong or runs nonstop

Compare against a known-good hygrometer. A dusty or failed humidity sensor, a set point too low for the space, or an undersized unit makes it run nonstop.

3 steps ~30 mineasy
Bucket full light (or P1/P2/Eb) stays on with an empty bucket · OnCall Tech