York / Coleman / Luxaire · Furnace error code

7 red flashesLockout: no ignition

Cross-checked High-voltage / caution

Unlock what this code means, its causes, tests and parts

Full library + AI assistant for $34.90, one time.

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

Related diagnostic guides

Guide · Furnace

Furnace blowing cold air on a heat call

The common causes are a fan set to ON, a dirty filter tripping the high limit so the burners stop while the blower runs, a full condensate drain on a high-efficiency furnace, or an ignition lockout. Gas valve and burner work is blocked; stop at diagnosis and refer.

4 steps ~45 minmoderate

Guide · Furnace

Furnace runs no heat (blower only or nothing)

Start with the board LED code, then work the call path: thermostat, 24 V, safeties, inducer, ignition, flame proving. Most no-heat calls end at a filter, a flame sensor, a pressure switch issue or gas being off.

5 steps ~45 minmoderate

Guide · Furnace

Burners light, then shut off after a few seconds (flame sensor)

The board must prove flame by flame rectification through the flame sensor. A dirty or oxidized sensor, poor ground or reversed polarity makes the board shut the gas off right after ignition.

5 steps ~30 mineasy