Miele · Dishwasher error code

F26Boiling protection: water too hot

Cross-checked High-voltage / caution

Unlock what this code means, its causes, tests and parts

Full library + AI assistant + the OnCall Tech app for iPhone & Android. $34.90, one time.

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

Related diagnostic guides

Guide · Dishwasher

Dishwasher 'Sanitized' light won't come on or flashes

The sanitized indicator only lights when the control measured that the water reached its sanitizing temperature and held it. When it fails, the water did not get hot enough or the cycle was interrupted. Check incoming hot water first (at least 120 F at the sink), then door openings and power interruptions, then the heater, thermistor and the control's heater circuit.

5 steps ~45 minmoderate

Guide · Dishwasher

Field pattern: Bosch dishwasher E09 / no heat (the heater is inside the circulation pump: check terminals and sensors before buying the assembly)

On most Bosch-built dishwashers the heater is built into the circulation pump housing (the 'heat pump'), so there is no visible element. E09 is tied to the heating circuit: the heater itself, its terminals, the temperature/flow sensing or the control's heater relay. The wrong turn is hunting for an element in the tub, or buying the heat pump assembly without measuring the heater and checking its connector for corrosion.

7 steps ~75 minadvanced

Guide · Dishwasher

Dishwasher cycle runs too long or stalls

Most long cycles are the control waiting for heat (cool supply, bad heater or thermistor) or a soil sensor reading dirty water. Check water temperature, then clean the turbidity sensor, then test thermistor and heater.

5 steps ~45 minmoderate