Lennox · Furnace error code

E228Pressure switch calibration unsuccessful

Single source High-voltage / caution

Unlock what this code means, its causes, tests and parts

Full library + AI assistant for $34.90, one time.

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

Related diagnostic guides

Component test · Furnace

How to test a gas furnace draft pressure switch (electrical and draft checks only)

The pressure switch proves the inducer is pulling enough draft before ignition is allowed. Test it with a meter (24 V across it) and a manometer against the set point printed on the switch. Gas valve, gas pressure and burner work are not covered: refer those to a licensed gas technician.

5 steps ~30 minadvanced

Guide · Furnace

Furnace runs no heat (blower only or nothing)

Start with the board LED code, then work the call path: thermostat, 24 V, safeties, inducer, ignition, flame proving. Most no-heat calls end at a filter, a flame sensor, a pressure switch issue or gas being off.

5 steps ~45 minmoderate

Guide · Furnace

Furnace short cycling (starts and stops quickly)

Short cycling is usually a safety opening mid-cycle (limit from low airflow, flame sensor dropping out, pressure switch opening) or a thermostat issue. Read the code and time the cycle.

4 steps ~45 minmoderate