Google Nest · Thermostat error code

E57 / E107Overcurrent on Y2

Single source High-voltage / caution

Unlock what this code means, its causes, tests and parts

Full library + AI assistant for $34.90, one time.

OnCall Tech is a reference tool for trained technicians and can make mistakes. Always disconnect power and confirm with the manufacturer's documentation before you work.

Related diagnostic guides

Guide · Thermostat

Indoor fan won't turn off from the thermostat

Start at the thermostat: fan set to ON instead of AUTO, or a setpoint the system can never reach. If the thermostat is right, the cause is in the equipment: a stuck fan relay, a limit switch keeping the blower on, a shorted G wire or a control board fault.

4 steps ~40 minmoderate

Guide · Thermostat

Thermostat shows WAIT or flashing 'Cool On'

Most thermostats hold the compressor off for a few minutes after it stops or after power returns, to prevent short cycling. That delay is normal. If the message lasts well past the delay or the system never starts, check mode, breakers, filter-related lockouts and wiring.

5 steps ~20 mineasy

Guide · Thermostat

Thermostat calls but heat or cooling does not start

Split the problem in two: is the thermostat sending 24 V on the call wire, and is the equipment responding to it? A jumper test at the board answers that in minutes.

5 steps ~40 minmoderate

More Google Nest thermostat codes

Google Nest · Thermostat

C wire required

Single source

Google Nest · Thermostat

E2 / E22 / E72 / E402

No power wire detected

Single source

Google Nest · Thermostat

E3 / E23

No power on the Rc wire

Single source High-voltage / caution

Google Nest · Thermostat

No power on the Rh wire

Cross-checked High-voltage / caution

Google Nest · Thermostat

E5 / E25 / E75 / E155 / E255 / E405

No heating or cooling wire detected

Single source

Google Nest · Thermostat

Too many wires

Single source